Preventive Maintenance; Lubrication And Adhesive Application - Epson DFX-8000 Service Manual

6.1 PREVENTIVE MAINTENANCE

and to minimize malfunction frequency.
Preventive maintenance includes regular cleaning of the case exterior, usingneutral detergent, and
occasional vacuuming of the mechanism interior to remove dust and paper particles.
Following cleaning, refer to Section 6.2 to verify that the unit is adequately lubricated. Before returning
the serviced printer to theconsumer,
of the unit.
Disconnect the printer from the power supply before performing maintenance. Do not use thinner,

6.2 LUBRICATION AND ADHESIVE APPLICATION

EPSON recommends that the points illustrated in Figures 6-2, 6-3 and 6-4 be lubricated, with EPSON
02 and G26, which have been extensively tested and found to comply with needs of this printer. (Refer
to Table 6-1 for details of 02 and G26.)
Table 6-2 indicated the lubricant for each points.
Be sure that the parts to be lubricated are clean before applying lubricant, and avoid excessive
application, which may damage related parts.
Adhesive application is necessary at the point indicated in Table 6-3 when the pan is disassembled
or replaced. EPSON recommends Neji Lock #2(G) adhesive be applied to the point diagramed in
Figures 6-2, 6-3 and 6-4.
Avoid overflow of excess to related parts.
Classification
Oil 0 2
Grease
Adhesive
NOTE:
EPSON = EPSON-exclusive product
inspect the springs, paper feed rollers, and the basic operation
W A R N I N G
Table 6-1. Lubricants and Adhesive
Description
Figure 6-1. Correct Adhesive Application
6-1
Capacity Availability
40CC EPSON
4 o g EPSON
Ooog
EPSON
Parts No.
B7 10200001
B 7 0 2 6 0 0 0 0 1
B 7 3 0 2 0 0 2 0 0