1.3.3
Hexadecimal Dump Function
The hexadecimal dump function prints out the data received by the printer in hexadecimal. On each
line, 16 bytes are printed in hexadecimal, and the ASCII character corresponding to each byte is printed
on the right side. "." is printed if there is no corresponding character (such as a control code).
If less than 16 bytes remain, they can be printed by pressing the ON LINE
switch.
By pressing both the LF switch and FF switch and applying power, the printer
is set to hexadecimal dump mode and prints "HEX DUMP MODE" on the first line.
The power should be turned off to cancel the hexadecimal dump mode.
Figure 1-29 shows a Hexadecimal Dump List.
Figure 1-29. Hexadecimal Dump List
1-25