DFX-8500
3.2.6.8 Upper Paper Guide and Top PE Sensor Removal
Step 1: Remove the paper bail assembly. (Refer to Section 3.2.6.7)
Step 2: Disconnect the red, 3-pin, top PE sensor connector from the connector junction board assembly.
Step 3: Remove the two CBS (M4x6) screws securing the upper paper guide to both frames and remove the
paper guide.
Step 4: Remove the two CPS(SP) (M3x8) screws securing the top PE sensor to the upper paper guide and
remove the sensor.
3-40
Figure 3-57. Top PE Sensor Connector Removal
Figure 3-58. Top PE Sensor Removal
Rev. B