3.2.7.8 Pull Tractor Sensor Removal
Step 1:
Remove the upper paper guide. (Refer to section 3.2.7.7.)
Remove the two CP (P) (M3 X 6) screws securing the terminal board to the printer mechanism,
Step 2:
then disconnect all the cables connecting
Remove the paper feed timing belt. It can
Step 3:
on the tension pulley.
Step 4:
Remove the tension roller gear on the left
by pulling it leftward while lifting the clip
Ten
river
Screw DI
Step 5:
Step 6:
leaf
spring, and shaft holder the same way as in Step 5.
Tension
Gear
Figure 3-42. Terminal Board Removal
Figure 3-43. Tension Roller Shaft Removal-1
3-35
the terminal board.
be removed easily by removing it while pushing
side of the tension roller shaft. Remove the gear
section with tweezers.
Pager Feed Timirm Belt
Leaf Sprin9