Technical Parameters - Ricoh Aficio SP 1100SF User Manual

Manual mode :
The machine proposes a 70 to 100 % reduction. Outside
these values, the machine beeps for error. This fixed
reduction will be used when printing received documents,
regardless of the used paper format.
To set the manual mode :
246 - SETUP / RECEPTION / REDUCTION
1 Select FIXED and confirm with OK.
2 Enter the reduction value (between 70 and 100)
and confirm with OK.
3 To exit this menu, press

Technical Parameters

As delivered your machine is preset by default. However,
you may adjust it to meet your requirements by resetting
the technical parameters.
To set the technical parameters:
1 Select the desired parameter and confirm with OK.
2 With the buttons
settings by following the table below and press OK.
Parameter
1 - Scanning mode Default value of the scan mode
resolution for the documents to be
transmitted.
2 - TX header If this parameter is on, your header will
appear on all documents sent to your
subscribers with your name, number,
date and number of pages.
Warning: If you send a fax from the
document loader, the transmission
header will not appear on the
document your correspondent
receives.
3 - TX speed Transmission speed for outgoing
documents.
For a quality telephone line
(compatible, no echo),
communications occur at maximum
speed.
However, it may be necessary to
restrict the transmission speed for
some calls.
4 - Echo protect If this parameter is on, the on-line echo
will be reduced during long distance
calls.
6 - EPT mode For some long distance calls (satellite),
the on-line echo may disturb the call.
.
29 - SETUP / TECHNICALS
or , modify the parameter
Signification
SP1100SF/Aficio SP1100SF
Parameter
7 - COM. display Choice between transmission speed
displayed or number of the page in
progress.
8 - Eco energy Choosing the printer standby delay: the
printer will switch to standby after a
delay (in minutes) of NON-operation or
during the period of time of your
choice.
Note: you can also access this
parameter by pressing the
from the idle screen.
10 - RX header If this parameter is on, all documents
received by your fax will include the
subscriber's header with his name,
number (if available) fax print date and
the page number.
11 - RX speed Transmission speed for incoming
documents.
For a quality telephone line
(compatible, no echo),
communications occur at maximum
speed.
However, it may be necessary to
restrict the transmission speed for
some calls.
12 - Rings Number of rings to automatically start
your machine.
13 - Discard size The Discard Size parameter only
defines the printing of received faxes .
The number of lines of a document can
be too high for the printing paper
format. This parameter defines the
threshold beyond which the extra lines
are printed on a second page. Bellow
this threshold, extras lines are deleted.
If you choose ON, the threshold is set
on 3 centimeters.
If you choose OFF, the threshold is set
on 1 centimeter.
20 - E.C.M. This parameter helps correct the calls
made on disturbed telephone lines. It
is used when the lines are weak or too
noisy. Transmission times may be
longer.
25 - TEL Impedance This parameter lets you choose
between a complex impedance and a
600 Ohm impedance, depending on
the telephone network your terminal is
connected to.
- 32 -
Signification
key