After Replacing The Drum Unit; Attaching The Drum Heater - Canon NP6218 Service Manual

4. After Replacing the Drum Unit

Whenever you have replaced the drum unit, enter the date of replacement and the
current counter reading on the label (Figure 10-226) that came with the drum unit; attach
the label to the front cover of the new drum unit, and perform the image basic adjustment
procedure.

5. Attaching the Drum Heater

1) Detach the front cover.
2) Open the copier's top body by operating the copier open/close lever.
3) Remove the two fixing screws
4) Detach the transfer roller and the static eliminator.
5) Detach the transfer guide.
6) Butt the two heaters against the transfer guide as shown in Figure 10-228, and fix the
two mounts with two screws
bands (front, rear).
COPYRIGHT © 1997 CANON INC.
Figure 10-226
, and detach the harness cover
Figure 10-227
; further, fix the harness in place using two harness
Figure 10-228
CANON NP6218 REV. 0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 10 TROUBLESHOOTING
.
10-23