Canon NP6218 Service Manual page 224

CHAPTER 8 INSTALLATION
Step
9 Select service mode No.
313/314, and enter the settings
recorded on the drum label.
To select service mode,
• Press the service mode
switch (SW302) with a hex
key.
Select '3' of the mode by
pressing '3' on the keypad
and AE key; then, select 'No.
3 xx' by pressing 'x' and 'x'
on the keypad and the start
key.
Execute 'No. 401' in service
10
mode.
• Press the service mode
switch (SW302), '4' on the
keypad, AE Key, and Start
key in sequence.
11 Make sure that step 10 has
been completed; then, turn off
the power, and open the
copier's top unit.
12 Remove the static eliminator,
and clean it with the static
eliminator brush; then, set the
static eliminator.
8-6
Work
COPYRIGHT © 1997 CANON INC.
To enter settings,
• Select 'No. 313' in service mode, and enter the
setting recorded on the label (PRIMARY) using
the keypad. (To enter '-', press the % key before
entering the setting.)
Then, press the Start key to store the setting.
To enter the setting for IP_OFST, select 'No. 314'
in service mode and work in the same way.
The copier supplies toner from the toner container
to the developing assembly (about 5 min).
Caution:
• Do not turn off the power or remove the door
switch actuator while the machine is operat-
ing.
CANON NP6218 REV. 0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
Remarks