Turning On The Copier - Canon NP6218 Service Manual

B. Turning On the Copier
Step
1 Connect the power plug to the
power outlet.
2 Turn on the power switch.
3 Turn off the power switch.
4 Supply toner according to the
instructions given on the toner
supply label attached behind
the front door.
5 Release the developing
assembly by the developing
assembly locking lever.
6 Install the drum unit.
7 Lock the developing assembly,
and close the copier's top unit.
8 Insert the door switch activator
into the door switch, and turn
on the power.
COPYRIGHT © 1997 CANON INC.
Work
CANON NP6218 REV. 0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
Caution:
• Make sure that the power outlet is the rating
±10%.
Make sure that the Add Paper message flashes.
• Press the keypad and the Clear key to make
sure that the copy count indication is correct.
Caution:
When turning the toner cartridge counterclock-
wise to set it, you must fully turn it until it is
locked; the developing assembly can cause a
fault if you operate the machine without locking
the cartridge.
See "D. Attaching the Drum Unit."
CHAPTER 8 INSTALLATION
Remarks
8-5