Starting And Stopping A Copying Job; Copy Settings - Olivetti Copia 9021 Instructions Manual

ST ST ST ST STAR AR ARTING AR TING AND ST TING TING AND ST AND STOPPING AND ST
AR TING AND ST
Press the START key (B38) to start the copy cycle. Once copying has started, it is no longer possible to change
the number of copies, the size, the copy ratio or any other settings, but the exposure level may be changed by
pressing the EXPOSURE keys (B20, B22).
To stop the photocopier before the end of the copy cycle, press the STOP key (B35).

COPY SETTINGS

COPY SETTINGS COPY SETTINGS
COPY SETTINGS COPY SETTINGS
Setting the number of copies
Before starting to copy, the desired number of copies can be set (1-100) by pressing the NUMERIC keys (B40).
To change the number of copies set previously or to correct a typing error, press the CLEAR key (B39).
Adjusting Copy Exposure
There are two ways of adjusting the copy exposure:
1. Automatic Control
Make sure that indicator A above the AUTOMATIC EXPOSURE key (B21) is on. If it is off, this means that
manual exposure control is active (see below).To activate automatic mode, press the AUTOMATIC EXPOSURE
key (B21).
!
When working with transparencies or other transparent originals, it may not be possible to use the
automatic exposure function. Should this be the case, adjust the exposure manually.
2. Manual Control
To adjust the exposure manually, press the MANUAL EXPOSURE keys (B20 and B22).
•
Press the B20 key to get a lighter copy or the B22 key to get a darker copy. The exposure indicator (B19) moving
to the left or right represents a scale of the available exposure levels.
•
If the MANUAL EXPOSURE keys (B20 and B22) are pressed when indicator A is on, automatic control is
disabled and indicator A goes off.
To adjust the exposure, should the copies not correspond to the original,
dark», p. 29.
Selecting the Paper Size
There are two ways of selecting the paper size:
1. Automatic selection
!
Automatic paper size selection cannot be used when working with transparencies or other transparent
documents, documents with a dark background, A5 or smaller documents or when Auto Zoom mode
is enabled ( «Auto Zoom», p. 15).
Automatic paper size selection is a standard setting, so no further setting is required. To disable it, press the
PAPER SELECT key (B28) until AUTO PAPER is indicated by the paper select indicators (B29).
When the document cover (A5) is lowered to start copying, the display (B12) indicates the selected size. If you
are using an optional ADF or RDF, this indication is given when you start copying by pressing the START key (B38).
8
COPIATURA DI BASE COPIATURA DI BASE COPIATURA DI BASE COPIATURA DI BASE COPIATURA DI BASE BASIC COPYING BASIC COPYING BASIC COPYING BASIC COPYING BASIC COPYING
OPPING A COPYING JOB OPPING OPPING A COPYING JOB A COPYING JOB A COPYING JOB
OPPING A COPYING JOB
«If the copies are too light or too