Aper Aper And Aper And; And Oner; Loading Copy Paper - Olivetti Copia 9021 Instructions Manual

P P P P P APER APER APER AND AND T T T T T ONER AND
APER APER AND AND
LO LOADING COPY P LO ADING COPY P ADING COPY P ADING COPY PAPER
LO LO ADING COPY P
When the paper in the selected cassette runs out, the paper out icon
panel, and the cassette in which there is no paper left is indicated on the paper out/jam indicator (B27).
•
The same indication is also given when the cassette is not correctly inserted.
•
If the indication is given before you have finished copying, load the paper and press the START key (B38) a
second time. The photocopier will print the remaining copies.
Loading paper into the cassettes
Grip the handle in the recess on the
front part of the cassette and pull it out
as far as it will go.
!
If you want to load paper of a different size into a cassette, remember to adjust the position of the paper
guides inside the cassette (
Adapting the cassettes to a different paper size
If you want to change the size of paper in a cassette, proceed as described below.
•
The cassettes can be adapted to the following standard paper sizes: A3, A4, A4R, A5, A5R. Use the stack bypass
for other paper sizes (
Length guide
Having removed the cassette, press
the lever on the guide used to regula-
te the length. Holding it pressed, slide
the guide to the mark corresponding
to the desired paper size.
24
ADDITIONAL FUNCTIONS ADDITIONAL FUNCTIONS ADDITIONAL FUNCTIONS ADDITIONAL FUNCTIONS ADDITIONAL FUNCTIONS
ONER ONER
ONER ONER
APER APER APER
APER
Open a pack of copy paper and take
out a stack of paper.
«Adapting the cassettes to a different paper size», below).
«Using the stack bypass», p. 11).
Press the lever on the guide used to
regulate the width. Holding it pres-
sed, slide the guide to the mark corre-
sponding to the desired paper size.
Turn the stack over and place it in the
cassette. The maximum paper level
is indicated by the
Push the cassette back in until it locks
into position.
Width guide
Press the paper size lever to select
the desired paper size.
Replace the cassette size label with
the one that corresponds to the new
paper size.
(B10) starts to blink on the control
symbol.