Assigning Telephone Buttons - AT&T MERLIN LEGEND Release 3.1 System Planning Manual

Assigning Telephone Buttons

2. For any
column of Form 2a, indicate the type of extension jack pairs under the
Extension Jack Pair heading on Forms 4b and 5a by doing one of the
following:
Check the Voice Announce to Busy (voice/voice) box and enter the
logical ID and extension number under the Even-numbered jack
heading.
Check the Simultaneous Voice and Data (voice/data) box and enter
the logical ID and extension number under the Even-numbered jack
heading.
3. For any adjuncts connected to an MLX telephone using an MFM, fill in the
following user information from Form 2b, System Numbering: Digital
Adjuncts on Forms 4e and 5c in the Connected to MLX extension No.
space:
a. Write the extension number in the Extension No. space.
b. Write the name of the person or the location of the equipment in the
Person or Location space.
4. Identify the equipment at each extension (see the floor plan):
a. Check the box that describes the telephone, console model, or type
of tip/ring equipment.
b. Check the box under Adjuncts that describes the adjuncts at the
extension. (Checking the Data terminal box is informational only.)
Assigning Telephone Buttons
This section contains instructions for assigning buttons to:
Telephones in Hybrid/PBX mode
Telephones in Key and Behind Switch mode
DLCs
Forms Needed
Form 4b, Analog Multiline Telephone
Form 4d, MLX Telephone
Form 4e, MFM Adjunct: MLX Telephone
Form 4f, Tip/Ring Equipment
Form 5a, Direct-Line Console (DLC): Analog
Form 5b, Direct-Line Console (DLC): Digital
Form 5c, MFM Adjunct: DLC
3–48
Lines/Trunks
voice/voice voice/data
or entries in the Person or Location