Configuring The Management Interface Vrf - Cisco ASR1002 - ASR 1002 Router Software Configuration Manual

How to Configure Call Home
•
How to Configure Call Home
To configure Call Home, complete the following tasks:
•
•
•
•
•
•
•

Configuring the Management Interface VRF

The Call Home feature on the Cisco ASR 1000 Series Routers requires use of the Gigabit Ethernet
Management interface virtual routing and forwarding (VRF) instance. The Gigabit Ethernet
Management interface is automatically part of its own VRF named "Mgmt-intf."
To configure the Management interface VRF, complete the following steps:
SUMMARY STEPS
1.
2.
3.
4.
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
4
If Cisco Smart Call Home is used, verify an active service contract exists for the device being
configured.
Configuring the Management Interface VRF, page 4
Configuring a Destination Profile, page 5
Subscribing to Alert Groups, page 17
Configuring Contact Information, page 21
Configuring the Number of Call Home Messages Sent Per Minute, page 23
Enabling and Disabling Call Home, page 23
Sending Call Home Communications Manually, page 24
configure terminal
interface GigabitEthernet 0
vrf forwarding Mgmt-intf
ip address ip-address mask [secondary [vrf vrf-name]]
or
ipv6 address {X:X:X:X::X link-local | X:X:X:X::X/prefix [anycast | eui-64] | autoconfig [default]}
(required)
(required)
(required)
(required)
(required)
(optional)
Configuring Call Home
(optional)