Configuring Gigabit EtherChannel for Virtual Private Wire Service
Ethernet-to-EtherChannel over MPLS (Bridge) Interworking mode is also supported under VLAN.
Note
Any-to-EtherChannel over MPLS (Routed) Interworking
You can configure Any-to-EtherChannel over MPLS (Routed) interworking on the Cisco ASR 1000
Series Routers.
Any-to-EtherChannel over MPLS (Routed) interworking supports the following modes:
•
•
•
Configure L2VPN interworking on the upstream interfaces of PE routers. For more information about
configuring L2VPN interworking on the PE routers, see
For information about how to configure ATM on the downstream interfaces of a PE router, see the
Configuring Frame Relay DLCI-to-ATM AAL5SNAP Bridged Interworking, page
perform the steps described in the
page
For the Ethernet-to-EtherChannel mode, see the
Interworking, page
For the PPP-to-EtherChannel mode, perform the steps described in the
over MPLS (Routed) Interworking, page
Meanwhile, perform the following steps on the downstream interfaces of the PE routers.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
26
ATM-to-EtherChannel
Ethernet-to-EtherChannel
PPP-to-EtherChannel
21, on the downstream interfaces of the other PE router.
24.
enable
configure terminal
(Optional) ipv6 unicast-routing
mpls ip default-route
mpls ldp graceful-restart
xconnect logging pseudowire status
controller t1 slot | subslot | port
clock source internal
linecode b8zs
cablelength long db-loss-value
channel-group channel-group-number timeslots range
exit
pseudowire-class pw-class-name
encapsulation mpls
interworking ethernet
exit
L2VPN Interworking Modes, page
EtherChannel-to-EtherChannel over MPLS (Routed) Interworking,
Any-to-EtherChannel over MPLS (Bridged)
21, on the downstream interfaces of the other PE router.
Configuring MPLS Layer 2 VPNs
2.
6. Meanwhile,
EtherChannel-to-EtherChannel