Cisco ASR1002 - ASR 1002 Router Software Configuration Manual page 389

Configuring MPLS Layer 2 VPNs
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
ipv6 unicast-routing
Example:
Router# ipv6 unicast-routing
Step 4
mpls label protocol ldp
Example:
Router(config)# mpls label protocol ldp
Step 5
mpls ip default-route
Example:
Router(config)# mpls ip default-route
Step 6
mpls ldp graceful-restart
Example:
Router(config)# mpls ldp graceful-restart
Step 7
frame-relay switching
Example:
Router(config)# frame-relay switching
Step 8
xconnect logging pseudowire status
Example:
Router(config)# xconnect logging pseudowire status
Step 9
controller t1 slot/subslot/port
Example:
Router(config)# controller T1 0/3/0
Step 10
framing esf
Example:
Router(config-controller)# framing esf
Configuring Frame Relay DLCI-to-ATM AAL5SNAP Bridged Interworking
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
Purpose
Enables the privileged EXEC mode.
Enter your password, if prompted.
Enters the global configuration mode.
(Optional) Enables the task of forwarding the IPv6
unicast datagrams.
Specifies the label distribution protocol (LDP) for
the Frame Relay PE router.
Enables the distribution of labels associated with the
IP default route.
Enables MPLS LDP graceful restart.
Enables PVC switching on a Frame Relay data
circuit-terminating equipment (DCE) device.
Enables system logging (syslog) reporting of
pseudowire status events.
Configures a T1 controller and enters the controller
configuration mode.
Selects the Extended Super Frame (ESF) for a T1
data line.
13