L2Vpn Interworking Modes; Ethernet Or Bridged Interworking - Cisco ASR1002 - ASR 1002 Router Software Configuration Manual

Overview of L2VPN Interworking
•
•
•
•
•
•
Overview of L2VPN Interworking
Interworking is a transforming function that interconnects two heterogeneous attachment circuits (ACs).
Several types of interworking functions exist. The function that is used depends on the AC type used,
the type of data carried, and the level of functionality required. The two main Layer 2 Virtual Private
Network (L2VPN) interworking functions supported in Cisco IOS XE software are bridged interworking
and routed interworking.
Layer 2 (L2) transport over multiprotocol label switching (MPLS) and IP exists for ACs, such as
Ethernet-to-Ethernet or Point-to-Point Protocol (PPP), Ethernet to VLAN, and Ethernet to Frame Relay.
An interworking function facilitates translation between different L2 encapsulations.

L2VPN Interworking Modes

L2VPN interworking works in either Ethernet (bridged) mode or IP (routed) mode. You can specify the
mode by issuing the interworking {ethernet | ip} command in the pseudowire-class configuration
mode.
The interworking command causes the ACs to be terminated locally. The two keywords perform the
following functions:
•
•
The following sections explain the Ethernet and IP interworking modes in detail.

Ethernet or Bridged Interworking

Ethernet interworking is also called bridged interworking. Ethernet frames are bridged across the
pseudowire. The CE routers can natively bridge Ethernet traffic or can route traffic using a bridged
encapsulation model, such as Bridge-group Virtual Interface (BVI) or Routed Bridge Encapsulation
(RBE). The PE routers operate in the Ethernet like-to-like mode.
The Ethernet interworking mode offers the following services:
•
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
2
Configuring Frame Relay DLCI-to-ATM AAL5SNAP Bridged Interworking, page 6
Gigabit EtherChannel for Virtual Private Wire Service, page 17
Configuring Gigabit EtherChannel for Virtual Private Wire Service, page 19
Additional References, page 30
Feature Information for Configuring MPLS Layer 2 VPNs, page 31
Glossary, page 33
The ethernet keyword causes Ethernet frames to be extracted from an AC and sent over the
pseudowire. Ethernet end-to-end transmission is resumed. The AC frames that are not Ethernet are
dropped. In the case of VLAN, the VLAN tag is removed, leaving an untagged Ethernet frame.
The ip keyword causes IP packets to be extracted from an AC and sent over the pseudowire. The AC
frames that do not contain IPv4 packets are dropped.
LAN services—An example of this is an enterprise that has several sites, with some sites having
Ethernet connectivity to the service provider (SP) network and others having Asynchronous
Transfer Mode (ATM) connectivity. If the enterprise requires LAN connectivity to all its sites, traffic
from the Ethernet or VLAN of one site can be sent through the IP/MPLS network and encapsulated
as bridged traffic over an ATM VC of another site.
Configuring MPLS Layer 2 VPNs