Cisco ASR1002 - ASR 1002 Router Software Configuration Manual page 206

Upgrade Process With Service Impact for Nonredundant Platforms
Command or Action
Step 10
redundancy force-switchover
Example:
Router# redundancy force-switchover
Step 11
(Optional) show platform
Example:
Router# show platform
Step 12
request platform software package install rp 0
file
file-system
:asr1000rp1-{rpaccess,rpios,rpcontrol
version-string
}* *.pkg bay
Example:
Router# request platform software package
install rp 0 file
bootflash:asr1000rp1-{rpaccess,rpios,rpcontrol}
*02.02.01.122-33.XNB1*.pkg bay 0 force
Step 13
request platform software package install rp 0
file
file-system
:asr1000rp1-{sipbase,sipspa}*
SIP-slot-number
pkg slot
Repeat this step for each SIP installed in your
router before proceeding to the next step.
Example:
Router# request platform software package
install rp 0 file
bootflash:asr1000rp1-{sipspa,sipbase}*02.02.01.
122-33.XNB1*.pkg slot 0 force
Router# request platform software package
install rp 0 file
bootflash:asr1000rp1-{sipspa,sipbase}*02.02.01.
122-33.XNB1*.pkg slot 1 force
Router# request platform software package
install rp 0 file
bootflash:asr1000rp1-{sipspa,sipbase}*02.02.01.
122-33.XNB1*.pkg slot 2 force
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
124
standby-bay
force
version
*.
force
Purpose
Force a switchover from the active IOS process to the
standby IOS process.
Note Your connection to the router often drops and is
expected behavior at this point of the procedure in
many scenarios.
If this step drops your connection to the router, wait
a few minutes before reconnecting to the router and
then continue to Step
(Optional) Monitor system state to ensure both IOS
processes are active.
Upgrade the RPAccess, RPIOS, and RPControl
subpackages in the standby bay, which in this context is the
opposite bay used in Step
The pattern options used in this CLI (rpaccess,
Note
rpios, and rpcontrol) were introduced in Cisco IOS
XE Release 2.1.2 and are not available in previous
Cisco IOS XE Releases.
See the "ISSU Procedures (Prior to Cisco IOS XE
Release 2.1.2)" section on page 74
IOS XE Release 2.1.2 ISSU upgrade procedures.
Upgrade the SIP and SPA subpackages for each SIP on the
router.
This step must be completed one SIP at a time, and
Note
repeated for each SIP installed on the router before
performing the next step.
You can use the show ip interface brief command
Tip
to identify which slots contain SIPs and SPAs. The
interfaces with three numbers (in the form
SIP-number/SPA-number/interface-number)
identify the SIP and SPA locations in the router.
The pattern options used in this CLI (sipbase and
Note
sipspa) were introduced in Cisco IOS XE Release
2.1.2 and are not available in previous Cisco IOS
XE Releases.
See the "ISSU Procedures (Prior to Cisco IOS XE
Release 2.1.2)" section on page 74
IOS XE Release 2.1.2 ISSU upgrade procedures.
Software Upgrade Process
11.
9.
for pre-Cisco
for pre-Cisco