Cisco ASR1002 - ASR 1002 Router Software Configuration Manual page 385

Configuring MPLS Layer 2 VPNs
Command or Action
Step 12
exit
Step 13
interface loopback loopback-interface-number
Example:
Router(config)# interface loopback 0
ip address
Step 14
ip-address mask
Example:
Router(config-if)# ip address 44.1.1.2
255.255.255.255
Step 15
exit
Step 16
interface GigabitEthernet slot/subslot/port
Example:
Router(config)# interface GigabitEthernet 0/0/1
Step 17
ip address ip-address mask
Example:
Router(config-if)# ip address 10.10.1.2
255.255.255.0
Step 18
negotiation auto
Example:
Router(config-if)# negotiation auto
Step 19
mpls ip
Example:
Router(config-if)# mpls ip
Step 20
exit
Step 21
interface atm slot/subslot/port
Example:
Router(config)# interface atm 0/1/2
Step 22
no ip address
Example:
Router(config-if)# no ip address
Step 23
atm clock internal
Example:
Router(config-if)# atm clock internal
Configuring Frame Relay DLCI-to-ATM AAL5SNAP Bridged Interworking
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
Purpose
Exits the pseudowire class configuration mode.
Specifies the loopback logical interface.
Specifies the IP address for the Loopback interface.
Exits the interface configuration mode.
Specifies the Gigabit Ethernet interface for the
connection of the PE routers.
Specifies the IP address for the Gigabit Ethernet
interface.
Enables the auto negotiation protocol to configure
the speed, duplex, and automatic flow control of the
Gigabit Ethernet interface.
Enables MPLS forwarding of the IPv4 packets
towards the MPLS core.
Exits the interface configuration mode.
Configures an ATM interface and enters the
interface configuration mode.
Removes the previously configured IP address.
Enables the ATM interface to generate the transmit
clock internally.
9