Example: Frame Relay-To-Atm Bridged Interworking On An Atm-Pe Router - Cisco ASR1002 - ASR 1002 Router Software Configuration Manual

Configuring Frame Relay DLCI-to-ATM AAL5SNAP Bridged Interworking
Command or Action
Step 24
no atm enable-ilmi-trap
Example:
Router(config-if)# no atm enable-ilmi-trap
Step 25
exit
Step 26
interface atm slot/subslot/port
[.subinterface-number {point-to-point}]
Example:
Router(config)# interface atm 0/1/2.1 point-to-point
Step 27
mtu bytes
Example:
Router(config-subif)# mtu 1500
Step 28
no atm enable-ilmi-trap
Example:
Router(config-subif)# no atm enable-ilmi-trap
Step 29
pvc [name] vpi/vci l2transport
Example:
Router(config-subif)# pvc cisco 10/100 l2transport
Step 30
encapsulation encapsulation-type
Example:
Router(config-if-atm-l2trans-pvc)# encapsulation
aal5snap
Step 31
xconnect peer-ip-address vc-id encapsulation mpls
pw-class pw-class-name
Example:
Router(config-if-atm-l2trans-pvc)# xconnect
190.1.1.1 100 encapsulation mpls pw-class
atm-fr-bridged
Step 32
exit

Example: Frame Relay-to-ATM Bridged Interworking on an ATM-PE Router

The following example shows the configuration of the Frame Relay-to-ATM Bridged Interworking
feature on an ATM-PE router:
no ip domain lookup
mpls label range 101 4000 static 4001 5001
mpls label protocol ldp
mpls ip default-route
mpls ldp graceful-restart
xconnect logging pseudowire status
!
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
10
Purpose
Disables the Integrated Local Management Interface
(ILMI) ATM traps.
Exits the interface configuration mode.
Configures an ATM interface and enters the
interface configuration mode.
Adjusts the maximum packet size or maximum
transmission unit (MTU) size.
The MTU sizes of both the attachment
Note
circuits must match.
Disables the ILMI ATM traps.
Assigns a name to an ATM PVC, specifies the
encapsulation type on an ATM PVC, and enters the
ATM virtual circuit configuration mode.
Sets the AAL5SNAP encapsulation (Any-to-Any)
for the ATM point-to-point interface.
Binds an attachment circuit to a pseudowire and
configures an Any Transport over MPLS (AToM)
static pseudowire.
Exits to the global configuration mode.
Configuring MPLS Layer 2 VPNs