Fresenius Medical Care 2008K Operator's Manual page 151

Message Purpose of Message
I2C Read Time Out Functional to I2C EEPROM
communication problem.
I2C Bus Read Error
I2C Bus Read Too Long
I2C Byte Write Error
In bypass for 8 min Press RESET to clear the message
Interrupt Rinse? Press confirm to interrupt rinse.
Interrupted The selected Rinse program has
been interrupted.
Entry value for [item] is out of range
Invalid Data Entry for
[item]
Invalid Data Entry for Entry value for bicarbonate is out of
bicarbonate range
Invalid Data Entry for Na Entry value for Na is out of range
Invalid UF Rate Entry value for goal is out of range.
Invalid UF Time Entry value for goal is out of range.
151
Type Action Required
Alarm Turn machine power off and back on. If alarm is not cleared, take the
machine out of service and alert a qualified technician.
Advisory The machine was in bypass for about eight minutes. This may
extend the time necessary to complete the treatment or rinsing of
germicide. Press RESET to clear the message.
Dialog Press CONFIRM to accept or press escape to cancel.
Message
Warning Re-insert the dialysate wands/connectors into the proper rinse ports.
To continue the Rinse or other program, press CONFIRM, then
reselect the desired program.
Set appropriate value for [item]
Dialog
Message
Enter the prescribed value for bicarbonate
Dialog
Message
Dialog Enter the prescribed value for Na
Message
Dialog Readjust rate
Message
Dialog Readjust time
Message
Troubleshooting
Warning! If rinsing germicide from the machine or
dialyzer when this occurs, additional time will be
necessary.
2008K Operator's Manual rev. K