Fresenius Medical Care 2008K Operator's Manual page 139

Message Purpose of Message
BVM No communication The BVM module has lost
communication with the 2008K
system.
Chem not Connected? The red wand/connector is still
connected to the red rinse port
Concentrate Connected? The red acid concentrate
wand/connector is not connected to
the concentrate container.
Cond Offset Failure Electronic self-test failure.
COND Ref Failure Electronic self-test failure.
Conductivity High
The actual or measured conductivity
has exceeded the high conductivity
alarm limit. The machine is in bypass
mode.
139
Type Action Required
Alarm Press RESET to clear the message. BVM will no longer pass
information to the 2008K monitor until power has been turned off and
back on. If alarm is not cleared, take the machine out of service and
alert a qualified technician.
Warning Connect the red (acetate) wand/connector into its correct
configuration for the operation selected.
Warning Connect the red (acid/acetate) wand/connector to the acid/acetate
supply.
Alarm Turn machine power Off and back On. If alarm is not cleared, take
the machine out of service and alert a qualified technician.
Alarm
Turn machine power Off and back On. If alarm is not cleared, take
the machine out of service and alert a qualified technician.
Dialysate 1) Check for the prescribed baseline Na
Alarm the "Dialysate" screen and re-enter the correct value for any
erroneous values. The SVS must be off before attempting to
adjust any parameter on this screen.
2) Check that the concentrates are properly mixed and in their
proper containers. Remix concentrates as needed.
3) Allow five minutes for conductivity to reach the prescribed level
and adjust the conductivity alarm limit window if necessary (see
"Conductivity Limits" on page 56.
4) Verify that there is flow out of the drain.
Troubleshooting
+
and Bicarbonate values on
2008K Operator's Manual rev. K