Macro Function - Epson L60IIP - TM B/W Direct Thermal Printer Information Manual

Macro Function Commands
The TM-L60II/L60IIP printers support the following macro function commands:
Command Name
GS : Start/end macro definition
GS ^ Execute macro
GS :
[Name] Start/end macro definition
[Format] ASCII
Hex
Decimal
GS ^ r t m
[Name] Execute macro
[Format] ASCII
Hex
Decimal
[Range] 0 r 255
0 t 255
0 m
GS : starts or ends macro definition. Macro definition starts when this command is received during
normal operation and ends when it is received during macro definition. Normal printing is
performed while the macro is being defined. If the printer receives this command again immediately
after previously receiving it, the printer remains in the macro undefined state. A macro is not defined
when the power is turned on.
The macro definition can contain up to 2048 bytes. If the macro definition exceeds this value, the
excess data is not stored.
GS ^ r t m executes a macro r times while waiting t 100 msec for each macro execution. When m=0,
the macro executes r times continuously at the interval specified by t. When m=1, the printer waits for
the period specified by t, blinks the LED indicator, and then waits for the PAPER FEED button to be
pressed. After this button is pressed, the printer executes the macro once. The printer repeats this
operation r times.
Rev. A
GS :
1D 3A
29 58
GS ^
1D 5E
29 94
1
TM–L60II/L60IIP Information Manual
r t m
r t m
r t m
Command Descriptions 1-55