Epson L60IIP - TM B/W Direct Thermal Printer Information Manual page 72

GS C 1 a a b b n r selects a count mode for the serial number counter. a
L H L H
counter range. n indicates the stepping amount when counting up or down. r indicates the repetition
number when the counter value is fixed. The default settings are as follows: a
b =255, n=1, r=1.
H
Count-up mode is specified when [a
equal to 0. In setting count-up mode, the minimum value of the counter is [a
maximum value is [b + b
L
resumed with the minimum value.
Count-down mode is specified when [a
not equal to 0. In setting count-down mode, the maximum value of the counter is [a
the minimum value is [b
resumed with the maximum value.
Counting stops when [a
GS C 2 n n sets the serial number counter value. n
L H
counter set by [n + n
L H
In count-up mode, if the counter value specified by this command goes out of the counter operation
range specified by the GS C 1 or GS C ; commands, it is forced to convert to the minimum value set
by the GS c command.
In count-down mode, if the counter value specified by this command goes out of the counter
operation range specified by the GS C 1 or GS C ; commands, it is forced to convert to the maximum
value set by the GS c command.
Program Example
PRINT #1, CHR$(&H1D);"C1";CHR$(1);CHR$(0);
CHR$(44);CHR$(1);CHR$(1);CHR$(1);
PRINT #1, CHR$(&H1D);"C2";CHR$(10);CHR$(0);
PRINT #1, CHR$(&H1D);"C0";CHR$(3);CHR$(1);
PRINT #1, "Line ";CHR$(&H1D);"c";CHR$(&HA);
PRINT #1, "Line ";CHR$(&H1D);"c";CHR$(&HA);
Rev. A
+ a 256] < [b
L H
256]. If counting up reaches a value exceeding the maximum, it is
H
+ a
L H
+ b 256]. If counting down reaches a value less than the minimum, it is
L H
+ a 256] = [b + b
L H L H
256]. The default setting is n
TM–L60II/L60IIP Information Manual
+ b 256] and n is not equal to 0 and r is not
L H
256] > [b + b 256] and n is not equal to 0 and r is
L H
256] or n= 0 or r = 0.
and n determine the value of the serial number
L H
=1, n =0.
L H
Print Sample
Line 010
Line 011
, a , b
, or b specify the
L H L H
=1, a =0, b =255,
L H L
+ a 256] and the
L H
+ a 256] and
L H
Command Descriptions 1-65