Epson L60IIP - TM B/W Direct Thermal Printer Information Manual page 20

ESC % n
[Name] Select/cancel user-defined character set
[Format] ASCII
Hex
Decimal
[Range] 0 n 255
ESC & y c1 c2 [x1 d1 ... d(y x1)] ... [xk d1 ... d(y
[Name] Define user-defined characters
[Format] ASCII
Hex
Decimal
y = 3
[Range]
32 c1
0 x 12 (12
0 x 9 (9 24 font)
0 d1...d (y x)
k = c2 - c1 + 1
ESC ? n
[Name] Cancel user-defined characters
[Format] ASCII
Hex
Decimal
32 n
[Range] 126
ESC % n selects or cancels the user-defined character set. When the LSB (least significant bit) of n is 1,
the user-defined character set is selected. When it is 0, the internal character set is selected; this is the
default setting.
ESC & y c1 c2 [x1 d1 ... d(y x1)] ... [xk d1 ... d(y xk)] defines user-defined characters from character
code c1 to c2. y and x are the configuration of a user-defined character. y specifies the number of
bytes in the vertical direction. x specifies the number of dots in the horizontal direction. Character
code range from ASCII code 20H (32) to 7EH (126) can be defined by c1 and c2. Data (d) specifies a bit
printed to 1 and not printed to 0. At the default, user-defined characters are not defined and the
internal character set is printed. Once the user-defined characters have been defined, they are
available until ESC @, ESC ?, or GS
power is turned off; or the printer is reset. The downloaded bit image is canceled.
Rev. A
ESC %
1B 25
27 37
(Only the least significant bit of n is enabled.)
ESC &
1B 26
27 38
c2 126
24 font)
255
ESC ?
1B 3F
27 63
is executed; the user-defined characters are redefined; the
TM–L60II/L60IIP Information Manual
n
n
n
xk)]
y c1 c2 [x1 d1 ... d(y x1)] ... [xk d1 ... d(y xk)]
y c1 c2 [x1 d1 ... d(y x1)] ... [xk d1 ... d(y xk)]
y c1 c2 [x1 d1 ... d(y x1)] ... [xk d1 ... d(y xk)]
n
n
n
Command Descriptions 1-13