Epson L60IIP - TM B/W Direct Thermal Printer Information Manual page 41

ESC T n
[Name] Set print direction in page mode
[Format] ASCII
Hex
Decimal
[Range] 0 n 3
48 n 51
ESC T n sets the print direction and starting position in page mode specified by n as shown below.
The default setting is n=0. This command is enabled only in page mode. If this command is entered in
standard mode, an internal flag is activated and the command is enabled when the printer returns to
page mode.
n Print Direction
0, 48 Left to right
1, 49 Bottom to top
2, 50 Right to left
3, 51 Top to bottom
The parameters for the horizontal or vertical motion units (x or y) differ depending on the starting
position of the printing area as follows:
If the starting position is the upper left or lower right of the printing area (n=0, 2, 48, or 50):
These commands use horizontal motion units: ESC SP, ESC $, ESC \
These commands use vertical motion units: ESC 3, ESC J, GS $, GS \
If the starting position is the upper right or lower left of the printing area (n=1, 3, 49, or 51):
These commands use horizontal motion units: ESC 3, ESC J, GS $, GS \
These commands use vertical motion units: ESC SP, ESC $, ESC \
1-34 Command Descriptions
ESC T
1B 54
27 84
Starting Position
Upper left (A in the figure)
Lower left (B in the figure)
Lower right (C in the figure)
Upper right (D in the figure)
n
n
n
A
Printing area
C
Rev. A