Epson L60IIP - TM B/W Direct Thermal Printer Information Manual page 34

ESC c 3 n
[Name] Select paper sensor(s) to output paper-end signals
[Format] ASCII
Hex
Decimal
[Range] 0 n
ESC c 3 n selects the paper sensor that outputs a paper-end signal to the parallel interface when a
paper-end is detected. The default setting is when all sensors are enabled (n= 15).
It is possible to select multiple sensors to output signals. Then, if any of the sensors detects a paper
end, the paper end signal is output. This command is available only with a parallel interface and is
ignored with a serial interface.
The paper sensor(s) used to output paper-end signals are selected by using n as follows:
Bit Off/On Hex Decimal
Off 00 0
0
On 01 1
Off 00 0
1
On 02 2
Off 00 0
2
On 02 4
Off 00 0
3
On 08 8
4-7 - - -
PRINT #1, CHR$(&H1B);"c3";CHR$(15);
Rev. A
ESC c
1B 63
27 99
5
Function
Paper roll near-end sensor disabled.
Paper roll near-end sensor enabled.
Paper roll near-end sensor disabled.
Paper roll near-end sensor enabled.
Paper roll end sensor disabled.
Paper roll end sensor enabled.
Paper roll end sensor disabled.
Paper roll end sensor enabled.
Undefined.
Program Example
All sensors enabled
TM–L60II/L60IIP Information Manual
3 n
n
33
51 n
Command Descriptions 1-27