Epson L60IIP - TM B/W Direct Thermal Printer Information Manual page 69

GS <
[Name] Initialize printer mechanism
[Format] ASCII
Hex
Decimal
GS < feeds label paper to the printing start position. This command is only effective when thermal
label is selected with the paper selection DIP switch, and does not initialize the values set by other
commands.
Program Example
PRINT #1, CHR$(&H1D);"<";
GS A m n
[Name] Adjust print starting position
[Format] ASCII
Hex
Decimal
[Range] 0 m 255
0 n 255
GS A m n adjusts the label print starting position in a selected direction, and by a specified amount
from the default position. This command is effective only when Thermal Label is selected with the
paper selection DIP switch. This command will be ignored unless it is received just after feeding a
label to the print starting position, using the FF, GS FF, or GS < commands, or by pressing the PAPER
FEED button, or at the time of power-on. The default setting is m=0, n=0. When executing the
commands, the paper is fed to adjust the print starting position of the current label, as follows.
m specifies the adjusting direction. When the LSB of m = 0, the label position is adjusted in the normal
direction. When the LSB of m = 1, the label position is adjusted in the reverse direction.
n specifies the adjustment amount. The adjustment amount formula is [n
inches. The vertical motion units use the vertical value set by the GS P. The default setting of the
vertical motion unit is 1/360 inch.
Program Example
PRINT #1, CHR$(&H1D);"A";CHR$(0);CHR$(18);
1-62 Command Descriptions
GS <
1D 3C
29 60
GS A m
1D 41 m
m
29 65
(Only the least significant bit of m is enabled.)
n
n
n
(vertical motion unit)]
Rev. A