Epson L60IIP - TM B/W Direct Thermal Printer Information Manual page 39

GS L n n
L H
[Name] Set left margin
[Format] ASCII
Hex
Decimal
[Range] 0 n 255
L
0 n
H
GS W n n
L H
[Name] Set printing area width
[Format] ASCII
Hex
Decimal
[Range] 0 n 255
L
0 n
H
GS L n n sets the left margin to [(n
L H
beginning of a line. The default setting is n
of a line in standard mode. If this command is entered in page mode, an internal flag is activated and
the command is enabled when the printer returns to standard mode.
GS W n n sets the printing area width to [(n
L H
left margin. The default setting is n
in standard mode. If this command is entered in page mode, an internal flag is activated and the
command is enabled when the printer returns to standard mode.
If the above commands set the printing area width to less than the width of one character, the
printing area width is extended to accommodate one character for the line.
The horizontal motion units use the horizontal value set by the GS P command. The default setting of
the horizontal motion unit is 1/180 inches.
Program Example
PRINT #1, CHR$(&H1D);"P";CHR$(180);CHR$(180);
PRINT #1, "01234567890123456789"; CHR$(&HA);
PRINT #1, CHR$(&H1D);"L";CHR$(60);CHR$(0);
PRINT #1, CHR$(&H1D);"W";CHR$(120);CHR$(0);
PRINT #1, "01234567890123456789"; CHR$(&HA);
1-32 Command Descriptions
GS L
1D 4C
29 76
255
GS W
1D 57
29 87
255
+ n 256) (horizontal motion unit)] inches from the
L H
=0, n
L
L
=0, n =2. This command is enabled only at the beginning of a line
L H
n n
L H
n n
L H
n n
L H
n n
L H
n n
L H
n n
L H
=0. This command is enabled only at the beginning
H
+ n 256) (horizontal motion unit)] inches from the
H
01234567890123456789
0123456789
0123456789
Left Printing area
margin width
Print Sample
Rev. A