Lacp Port Configuration - NETGEAR GS728TS Admin Manual
Gigabit smart switches
Hide thumbs
Also See for GS728TS:
- Hardware installation manual (42 pages) ,
- Specifications (3 pages) ,
- Installation manual (2 pages)
Table of Contents
Advertisement
GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches
LACP Port Configuration
To display the LACP Port Configuration page, click Switching> LAG > Advanced > LACP
Port Configuration.
To configure LACP port priority settings:
1.
Select the check box next to the port to configure. You can select multiple ports to apply
the same setting to all selected ports.
Note:
You cannot select ports that are not participating in a LAG.
2.
Configure the LACP Priority value for the selected port. The field range is 0–255. The
default value is 128.
3.
Configure the administrative LACP Timeout value.
•
Long. Specifies a long timeout value.
•
Short. Specifies a short timeout value.
4.
Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
5.
If you make any changes to this page, click Apply to send the updated configuration to the
switch. Configuration changes take effect immediately.
109
Advertisement
Table of Contents
