Snmp; Snmpv1/V2 - NETGEAR GS728TS Admin Manual

GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches

SNMP

From SNMP link under the System tab, you can configure SNMP settings for SNMPv1/v2
and SNMPv3.
From the SNMP link, you can access the following pages:
•

SNMPv1/v2

on page 75
• Trap Flags on page 78
• SNMP v3 User Configuration
SNMPv1/v2
The pages under the SNMPv1/v2 menu allow you to configure SNMP community
information, traps, and trap flags.
Community Configuration
To display this page, click System > SNMP > SNMP V1/V2 > Community Configuration.
By default, two SNMP Communities exist:
• Private, with Read/Write privileges and status set to Enable.
• Public, with Read Only privileges and status set to Enable.
These are well-known communities. Use this page to change the defaults or to add other
communities. Only the communities that you define using this page will have access to the
switch using the SNMPv1 and SNMPv2c protocols. Only those communities with read/write
level access can be used to change the configuration using SNMP.
Use this page when you are using the SNMPv1 and SNMPv2c protocol.
on page 79
75