NETGEAR GS728TS Admin Manual page 244

Gigabit smart switches
Hide thumbs Also See for GS728TS:
Table of Contents

Advertisement

GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches
To configure rules for an IP ACL:
1.
To add an IP ACL rule, select the ACL ID to add the rule to and click Add.
The page refreshes and shows the available rules to configure.
2.
Complete the fields described in the following list.
Rule ID. Specify a number from 1–10 to identify the IP ACL rule. You can create up to
10 rules for each ACL.
Action. Selects the ACL forwarding action, which is one of the following:
Permit. Forwards packets which meet the ACL criteria.
Deny. Drops packets which meet the ACL criteria.
Egress Queue. Specifies the hardware egress queue identifier used to handle all
packets matching this ACL rule. Enter an identifying number from 0–6 in the
appropriate field.
Logging. When logging is enabled for a rule, the switch periodically sends a message
to the log file indicating the number of times a packet matched the rule during that
time period. If the Access List Trap Flag is also enabled, this will cause periodic traps
to be generated indicating the number of times this rule was hit during the current
report interval. A fixed five-minute report interval is used for the entire system. A trap
is not issued if the ACL rule hit count is zero for the current interval. This field is only
supported for a Deny action.
244

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gs752tpsGs752tsGs728tps

Table of Contents