Ipv6 Network Neighbor - NETGEAR GS728TS Admin Manual

GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches
To configure the network information for an IPv6 network:
1. Admin Mode. Enable or disable the IPv6 network interface on the switch. The default
value is Enable.
2. IPv6 Address Auto Configuration Mode. The IPv6 address for the IPv6 network interface
is set in auto configuration mode if this option is enabled. The default value is Disable. Auto
configuration can be enabled only when DHCPv6 is not enabled on any of the management
interfaces.
3. Current Network Configuration Protocol. The IPv6 address for the IPv6 network interface
is configured by DHCPv6 protocol if this option is enabled. The default value is None.
DHCPv6 can be enabled only when IPv6 Auto configuration or DHCPv6 are not enabled on
any of the management interfaces.
4. DHCPv6 Client DUID. Identifier used to identify the client's unique DUID value. This option
only displays when DHCPv6 is enabled.
5. IPv6 Gateway. Specify the gateway for the IPv6 network interface. The gateway address is
in IPv6 global or link-local address format.
6. IPv6 Prefix/Prefix Length. Add the IPv6 prefix and prefix length to the IPv6 network
interface. The address is in the global address format.
7. EUI64. Specify whether format IPv6 address in EUI-64 format. The default value is False.
8. Click Add to add a new IPv6 address in global format.
9. Click Delete to delete a selected IPv6 address.
10. Click Apply to apply the changes to the system.
11. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.

IPv6 Network Neighbor

Use the IPv6 Network Neighbor page to view the IPv6 Network Interface IPv6 Neighbor
Table. If no IPv6 neighbors are detected on the network, the table is empty.
To access the page, click System
to the following is displayed.
 
Management IPv6 Network Neighbor. A screen similar
38