Lacp Port Configuration - NETGEAR GS748Tv4 Software Administration Manual

GS748T Smart Switch Software Administration Manual
1. From the LACP System Priority field, specify the device's link aggregation priority
relative to the devices at the other ends of the links on which link aggregation is
enabled. A higher value indicates a lower priority. You can change the value of the
parameter globally by specifying a priority from 0–65535. The default value is 32768.
2. Click Refresh to reload the page and display the most current information.
3. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
4. If you make any changes to this page, click Apply to send the updated configuration to the
switch. Configuration changes take effect immediately.

LACP Port Configuration

To display the LACP Port Configuration page, click Switching > LAG > Advanced > LACP
Port Configuration.
To configure LACP port priority settings:
1. Select the check box next to the port to configure. You can select multiple ports to apply
the same setting to all selected ports.
Note: You cannot select ports that are not participating in a LAG
2. Configure the LACP Priority value for the selected port. The field range is 0–255. The
default value is 128.
3. Configure the administrative LACP Timeout value.
• Long. Specifies a long timeout value.
• Short. Specifies a short timeout value.
Chapter 3: Configuring Switching Information | 83