NETGEAR GS728TS Admin Manual page 239

GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches
MAC addresses with aa:bb:xx:xx:xx:xx result in a match (where x is any hexadecimal
number). A MAC mask of 00:00:00:00:00:00 matches a single MAC address.
• EtherType Key. Requires a packet's EtherType to match the EtherType you select.
Select the EtherType value from the drop down menu. If you select User Value, you
can enter a custom EtherType value.
• EtherType User Value. This field is configurable if you select User Value from the
EtherType drop down menu. The value you enter specifies a customized Ethertype to
compare against an Ethernet frame. The valid range of values is 0x0600–0xFFFF.
• Source MAC. Requires a packet's source port MAC address to match the address
listed here. Enter a MAC address in the this field. The valid format is
xx:xx:xx:xx:xx:xx.
• Source MAC Mask. If desired, enter the MAC mask for the source MAC address to
match. Use Fs and zeros in the MAC mask, which is in a wildcard format. An F means
that the bit is not checked, and a zero in a bit position means that the data must equal
the value given for that bit. The valid format is xx:xx:xx:xx:xx:xx. A MAC mask of
00:00:00:00:00:00 matches a single MAC address.
• VLAN. Requires a packet's VLAN ID to match the ID listed here. Enter the VLAN ID to
apply this criteria. The valid range is 1–4093.
• Logging. When logging is enabled for a rule, the switch periodically sends a
message to the log file indicating the number of times a packet matched the rule
during that time period. If the Access List Trap Flag is also enabled, this will cause
periodic traps to be generated indicating the number of times this rule was hit during
the current report interval. A fixed five-minute report interval is used for the entire
system. A trap is not issued if the ACL rule hit count is zero for the current interval.
This field is only supported for a Deny action.
3. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
4. To delete a rule, select the check box associated with the rule and click Delete.
5. To change a rule, select the check box associated with the rule, change the desired fields
and click Apply.
239