Dual Image Configuration - NETGEAR GS728TS Admin Manual

GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches
To copy an image:
1. Use the Source Image field to select the image on the stack master to use as the
source. The source image overwrites the destination image, if it exists.
2. Use the Stack Member menu to select the destination unit to which you are going to
copy the image. To copy the selected image from the stack master to all stack members,
select All.
3. Use the Destination Image field to determine which image on the stack member(s) to
overwrite (if an image currently exists in the selected destination). The image on the
stack master is copied to the destination you select.
4. Click Cancel to cancel the configuration on the screen. Reset the data on the screen to the
latest value of the switch.
5. Click Apply to initiate the file transfer from the stack master to the selected stack member.

Dual Image Configuration

The system running a legacy software version will ignore (not load) a configuration file
created by the newer software version. When a configuration file created by the newer
software version is discovered by the system running an older version of the software, the
system will display an appropriate warning to the user.
Use the Dual Image Configuration page to set the boot image, configure an image
description, or delete an image.
To display the Dual Image Configuration page, click Maintenance > File Management > Dual
Image > Dual Image Configuration.
289