Lldp - NETGEAR GS728TS Admin Manual

GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches
The SNMPv3 Access Mode is a read-only field that shows the access privileges for the user
account. The admin account always has Read/Write access, and all other accounts have
Read Only access.
To configure SNMPv3 settings for the user account:
1. In the Authentication Protocol field, specify the SNMPv3 Authentication Protocol setting
for the selected user account. The valid Authentication Protocols are None, MD5, or
SHA. If you select:
• None: The user will be unable to access the SNMP data from an SNMP browser.
• MD5 or SHA: The user login password will be used as SNMPv3 authentication
password, and you must therefore specify a password. The password must be eight
characters in length.
2. In the Encryption Protocol field, choose whether to encrypt SNMPv3 packets transmitted by
the switch.
• None. Do not encrypt the contents of SNMPv3 packets transmitted from the switch.
• DES. Encrypt SNMPv3 packets using the DES encryption protocol.
3. If you selected DES in the Encryption Protocol field, enter the SNMPv3 Encryption Key here.
Otherwise, this field is ignored. Valid keys are 0 to 15 characters long.
4. Click Apply to send the updated configuration to the switch. Configuration changes take
effect immediately.
5. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.

LLDP

The IEEE 802.1AB-defined standard, Link Layer Discovery Protocol (LLDP), allows stations
on an 802 LAN to advertise major capabilities and physical descriptions. This information is
viewed by a network manager to identify system topology and detect bad configurations on
the LAN.
From the LLDP link, you can access the following pages:
• LLDP Configuration
• LLDP Port Settings
• LLDP-MED Network Policy
• LLDP-MED Port Settings
• Local Information
• Neighbors Information
LLDP is a one-way protocol; there are no request/response sequences. Information is
advertised by stations implementing the transmit function, and is received and processed by
stations implementing the receive function. The transmit and receive functions can be
enabled/disabled separately per port. By default, both transmit and receive are enabled on all
on page 81
on page 82
on page 83
on page 85
on page 86
on page 88
80