NETGEAR GS728TS Admin Manual page 264

GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches
Field
Alignment Errors
Rx FCS Errors
Overruns
Total Received Packets Not
Forwarded
Local Traffic Frames
802.3x Pause Frames
Received
Unacceptable Frame Type
Multicast Tree Viable
Discards
Reserved Address Discards The number of frames discarded that are destined to an IEEE 802.1 reserved
Broadcast Storm Recovery
CFI Discards
Upstream Threshold
Total Packets Transmitted
(Octets)
Packets Transmitted 64
Octets
Packets Transmitted
65-127 Octets
Packets Transmitted
128-255 Octets
Description
The total number of packets received that had a length (excluding framing bits,
but including FCS octets) of between 64 and 1518 octets, inclusive, but had a
bad Frame Check Sequence (FCS) with a non-integral number of octets.
The total number of packets received that had a length (excluding framing bits,
but including FCS octets) of between 64 and 1518 octets, inclusive, but had a
bad Frame Check Sequence (FCS) with an integral number of octets
The total number of frames discarded as this port was overloaded with
incoming packets, and could not keep up with the inflow.
A count of valid frames received which were discarded (i.e., filtered) by the
forwarding process.
The total number of frames dropped in the forwarding process because the
destination address was located off of this port.
A count of MAC Control frames received on this interface with an opcode
indicating the PAUSE operation. This counter does not increment when the
interface is operating in half-duplex mode.
The number of frames discarded from this port due to being an unacceptable
frame type.
The number of frames discarded when a lookup in the multicast tree for a
VLAN occurs while that tree is being modified.
address and are not supported by the system.
The number of frames discarded that are destined for FF:FF:FF:FF:FF:FF
when Broadcast Storm Recovery is enabled.
The number of frames discarded that have CFI bit set and the addresses in
RIF are in non-canonical format.
The number of frames discarded due to lack of cell descriptors available for
that packet's priority level.
The total number of octets of data (including those in bad packets) transmitted
on the network (excluding framing bits but including FCS octets). This object
can be used as a reasonable estimate of ethernet utilization. If greater
precision is desired, the etherStatsPkts and etherStatsOctets objects should
be sampled before and after a common interval.
The total number of packets (including bad packets) transmitted that were 64
octets in length (excluding framing bits but including FCS octets).
The total number of packets (including bad packets) transmitted that were
between 65 and 127 octets in length inclusive (excluding framing bits but
including FCS octets).
The total number of packets (including bad packets) transmitted that were
between 128 and 255 octets in length inclusive (excluding framing bits but
including FCS octets).
264