Switch Discovery In A Network Without A Dhcp Server - NETGEAR GS728TS Admin Manual

GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches

Switch Discovery in a Network without a DHCP Server

This section describes how to use the Smart Control Center to set up your switch in a
network without a DHCP server. If your network has no DHCP service, you must assign a
static IP address to your switch. If you choose, you can assign it a static IP address, even if
your network has DHCP service.
To assign a static IP address:
1. Connect the switch to your existing network.
2. Power on the switch by plugging in the AC-DC power adapter.
3. Install the Smart Control Center on your computer.
4. Start the Smart Control Center.
5. Click Discover for the Smart Control Center to find your GS728TS, GS728TPS, GS752TS,
or GS752TPS switch. The utility broadcasts Layer 2 discovery packets within the broadcast
domain to discover the switch.You should see a screen similar to
6. Select the switch, then click Configure Device. The page expands to display additional
fields at the bottom of the page, as the following figure shows.
14
Figure 1 on page 12.