Resetting Nvram - Xerox 2135DX - Phaser Color Laser Printer Service Manual

Resetting NVRAM

Resetting NVRAM returns all the image processor's NVRAM-stored parameters,
including the network card, to their factory defaults except the print counts and
the Adobe firmware serial number. This procedure reset all values, including
language and color balance, to the factory default values. Event logs cannot
cleared.
1. Turn off the printer.
2.
Press and hold-down the On Line (0) key and the Enter (4) keys.
3.
Turn on the printer. When the message Ready will be displayed use the
the Menu (1, 4) keys to scroll through the list of menu items to the menu
item Reset Menu. Press Enter (4).
4.
Use the Menu (1, 4) keys to scroll through the list of reset options:
Factory Defaults. (print engine settings)
Use the Item (2, 6) keys to activate the Confirm Action Yes/No menu.
Press Enter to confirm your selection.
Network Defaults. (network settings)
Use the Item (2, 6) keys to activate the Confirm Action Yes/No menu.
Press Enter to confirm your selection.
Demo Mode.
Use the Item (2, 6) keys to activate the Confirm Action Yes/No menu.
Press Enter to confirm your selection.
CRU Reset. (consumable print counts)
Use the Item (2, 6) keys to scroll through the list of consumable items.
Use the Value (2, 6) keys to activate the Confirm Action Yes/No menu for
the consumable item displayed. Press Enter to confirm your selection.
Alternately, refer to the service test procedure "Consumable count initialization"
on page 73 to reset the print engine's NVRAM-stored consumable counts or the
registration set points parameters.
A customer-accessible NVRAM reset is available through the front panel menu
item Support Menu. This reset returns the printer to its factory-default settings
but does not clear copy counts nor consumable counts.
Service Guide
85