Rear cover
Warning
Switch off the power and disconnect the power cord.
1.
Remove the system controller board as explained in "System controller
board" on page 105.
2.
Open the top cover. Remove the drum/toner cartridges. Place them in
a lightproof black bag to protect the drum units from light and store in a
safe place.
3.
Remove the seven screws securing the rear cover to the printer.
Remove the rear cover.
Removing the rear cover
Reverse the removal steps to install the rear cover.
Remove
B
Screws
G
0725-11
Service Guide
G
G
G
Rear Cover
89