Rear Power Supply Fan; Removing The Rear Power Supply Fan - Xerox 2135DX - Phaser Color Laser Printer Service Manual

Rear power supply fan

Warning
Switch off the power and disconnect the power cord.
1.
Open the top cover. Remove the drum/toner cartridges. Place them in
a lightproof black bag to protect the drum units from light and store in a
safe place.
2.
Remove the electrical card cage as described in "Electrical card cage" on
page 98.
3.
Remove the left-side cover as described in "Left-side cover" on page 91.
4.
Remove the left shield plate.
5. Disconnect the rear power supply fan's wiring harness from the engine
controller board.
6. Remove the screw securing the fan to the fan duct. Slide the rear power
supply fan out of the duct. Two screws secure the duct in place.
Remove
Screws

Removing the rear power supply fan

Reverse these steps to install the rear power supply fan. Ensure the fan blows
outward from the printer unit chassis.
96 Phaser 2135 Color Printer
Rear Power Supply
and Duct Fan
Air Flow
0725-20