Resetting Nvram - Xerox WorkCentre C2424DX Service Manual

Disabling Jet Substitution Mode
After the printhead is replaced, disable Jet Substitution Mode to restore normal
operation.
Using the hidden Jet Substitution Mode Menu, select
1. System
First press
2.
From the menu, scroll to
3. Print Quality
Scroll to
4. Press and hold the Up Arrow button, and then press the Back button.
5. Turn Jet Substitution Mode
Scroll to
6.
Print the Eliminate Light Stripes test page to verify that Service Mode is disabled
for all jets.

Resetting NVRAM

Resetting NVRAM returns all the Image Processor Board NVRAM-stored
parameters to their factory default values. The print counts and the Adobe firmware
serial number are not affected by this reset. You can reset the PostScript NVRAM
using the Service Tools Menu or the Service Diagnostics Menu.
Adjustments and Calibrations
Setup, and then enter the Information Menu.
Troubleshooting,
Problems, and then press the OK button.
Jet Select.
and then press the OK button.
Off, and then press the OK button.
6-13