Registration Motor Assembly; Removing The Registration Motor Assembly - Xerox 2135DX - Phaser Color Laser Printer Service Manual

Registration motor assembly

Warning
Switch off the power and disconnect the power cord.
1.
Open the top cover. Remove the drum/toner cartridges. Place them in
a lightproof black bag to protect the drum units from light and store in a
safe place.
2.
Open the front cover.
3.
Remove the rear shield plate as described in the topic "Rear shield
plate" on page 97.
4.
Remove the registration clutch as detailed in "Registration clutch" on
page 125.
5.
Remove the screws securing the motor bracket to the printer.
6. Remove the registration motor assembly.
7.
Disconnect the harness from the registration motor.
8. If replacing the motor, remove the two screws securing the motor to the
motor bracket.

Removing the registration motor assembly

Reverse these steps to install the registration motor assembly.
126 Phaser 2135 Color Printer
Registration Motor
0725-37
Ground Plate
Remove
Screws