Belt Entrance And Multi-Sheet Bypass Feed Sensor Actuators; Removing The Belt Entrance Sensor Actuator - Xerox 2135DX - Phaser Color Laser Printer Service Manual

Belt entrance and multi-sheet bypass feed sensor actuators

Warning Switch off the power and disconnect the power cord.
1.
Remove the printer unit chassis described in the topic "Printer unit
chassis" on page 100.
2.
Remove the Tray 1 entrance sensor actuator as described in the topic
"Tray 1 entrance sensor actuator" on page 121.
3.
Remove the entrance sensor board as described in the topic "Entrance
sensor board" on page 111.
4.
From the bottom, squeeze the two locking tabs securing the belt
entrance sensor actuator.
5.
Remove the actuator from the top.
0725-34

Removing the belt entrance sensor actuator

Reverse these steps to install the actuators. For reassembly, install the sensor
actuator and ensure the spring arm is properly located in the notch in the printer
unit chassis.
122 Phaser 2135 Color Printer
Multi-sheet Bypass Feed
Sensor Actuator
Belt Entrance
Sensor Actuator