Electronic Boards; System Controller Board; Removing The System Controller Board - Xerox 2135DX - Phaser Color Laser Printer Service Manual

Electronic boards

System controller board

Warning Switch off the power and disconnect the power cord.
1.
Disconnect all cables connected to the rear of the system controller
board.
2.
Remove the two screws securing the system controller board to the
printer.
3.
Slide the system controller board out to the rear of the printer.
.

Removing the system controller board

Reverse these steps to install the system controller board. Transfer the RAM
DIMMs and the hard drive from the old board to the new board.
0725-23
Service Guide 105