Transfer Belt Unit; Removing The Transfer Belt Unit - Xerox 2135DX - Phaser Color Laser Printer Service Manual

Transfer belt unit

Warning
Switch off the power and disconnect the power cord.
1.
Open the top cover.
2. Remove the drum unit caddy. Cover the drum units and store in a safe
place.
3. Push the transfer belt unit locking tabs toward the left side of the
printer to release the unit.
4. Using the transfer belt unit handle, lift the unit about 1/2 inch (12 mm).
5.
Using the handle and the front frame of the transfer belt unit, remove
the unit.
Push Back
Locking Tabs

Removing the transfer belt unit

Reverse these steps to install the transfer belt unit. Ensure the transfer belt unit's
locking tabs fully engage.
124 Phaser 2135 Color Printer
Lift
Transfer Belt Unit
0725-35