Resetting All Printer Default Settings (Postscript Nvram); Using Main Menu - Xerox Phaser 4500 Service Manual

Resetting All Printer Default Settings (PostScript NVRAM)

Phaser 4500/4510 Service Manual
Resetting the PostScript NVRAM restores all printer values stored in the
Image Processor controller NVRAM (including network, printer setup, job
defaults, and margin) to their factory default values. The print counts and the
Adobe firmware serial number are not affected by this reset.
Caution
Before resetting the printer default settings to factory default values, make
note of the current network settings or print a configuration page to record
the customer's current network settings.
You can reset the PostScript NVRAM by:
Using the Main Menu
Using the Service Diagnostics Menu
Using the control panel shortcut
Using the Main Menu
1. From the Main Menu, select Troubleshooting, then press the OK button.
2. Select Service
3. Select Reset
4. Select Reset NVRAM and Reset Printer
to reset all the settings to their factory default values.
Using the Service Diagnostics Menu
1. Enter Service Diagnostics.
2. Select Controller NVRAM
3. With Reset PostScript NVRAM
4. Enter the password (4370) when prompted.
a. Use the Up or Down buttons to change the value of each digit.
b. Shift to the next digit by pressing the OK button.
c. Press the red Cancel button to enter the password.
5. When Resetting NVRAM! Are you sure?
press the OK button.
The printer then exits Service Diagnostics and reboots. While booting,
NVRAM is reset.
Using the Control Panel Shortcut
1. At power-on, press the Back + OK buttons together.
2. When Password
buttons together within 2 seconds.
Tools, then press the OK button.
NVRAM, press the OK button.
Access, then press the OK button.
highlighted, press the OK button.
appears, press and hold the Up Arrow + Down Arrow
Adjustments and Calibrations
NOW, then press the OK button
is displayed, highlight Yes and
6-13