Duplex unit
Warning
Switch off the power and disconnect the power cord.
Note
The duplex unit and Tray 1 are interlocked. The duplex unit
cannot be removed without the paper tray.
1.
Open the duplex unit release cover.
2.
Pull the duplex unit release handle and pull out the duplex tray and
Tray 1 together until they stop.
3.
Lift the front of the duplex unit and tray 1 and pull the right side out
slightly to free them from the printer.
4.
Slide the release lever to raise the two spring-loaded guide pins that
align the duplex unit to tray 1. The release lever is located next to the
right guide pin on the inside lip near the front of the duplex unit.
5.
Holding tray 1 still, force the duplex unit backwards about 5 cms (2 ins.)
Lift the duplex unit to separate it from the paper tray.
Slide release
lever ...
Tray 1
Removing the duplex unit
Reverse these steps to install the duplex unit.
Duplex Unit
...and then
force duplex
unit back and up
0725-55
Service Guide
151