Installing The Server; Safety Information; Installation Sequence And Checklist - HP Integrity rx2800 - i2 User's & Service Manual

3 Installing the server

Safety information

Follow the instructions carefully to prevent injury and equipment damage when performing removal
and replacement procedures. Voltages can be present within the server. Many assemblies are
sensitive to damage by ESD.
Follow the safety conventions listed to ensure safe handling of components, to prevent injury, and
to prevent damage to the server:
If installing a hot swap or hot plug component when power is applied (fans are running),
reinstall the server cover immediately to prevent overheating.
If installing a hot plug capable component, complete the required software intervention prior
to removing the component.
If installing an assembly that is neither hot swap nor hot plug, disconnect the power cable
from the external server power receptacle before starting the installation.
WARNING!
from the server before removing or installing server hardware (unless you are removing or
installing a hot-swappable or hot-pluggable component). Voltages are present at various
locations within the server whenever an ac power source is connected. This voltage is present
even when the main power switch is off. Failure to observe this warning can result in personal
injury or equipment damage.
Do not wear loose clothing that can snag or catch on the server or on other components.
Do not wear clothing subject to static charge buildup, such as wool or synthetic materials.
If installing an internal assembly, wear an antistatic wrist strap and use a grounding mat, such
as those included in the Electrically Conductive Field Service Grounding Kit.
Handle accessory boards and components by the edges only. Do not touch any metal edge
connectors or any electrical components on accessory boards.

Installation sequence and checklist

Step Description
1 Unpack and inspect the server shipping container. Inventory the contents using the packing
slip.
2 Install any additional components shipped with the server.
3 Install the server into a rack or pedestal.
4 Connect cables to the server.
a. Connect ac input power cable.
b. Connect LAN core I/O cable.
c. Connect iLO 3 MP LAN cable.
5 Connect and set up the console for access.
6 Power on the server.
7 Access the console.
8 Verify components in the server.
26 Installing the server
Ensure that the system is powered off and all power sources are disconnected
Completed