Configuring The Ilo 3 Mp Lan Using Dhcp And Dns; Configuring The Ilo 3 Mp Lan Using The Rs-232 Serial Port - HP Integrity rx2800 - i2 User's & Service Manual

Table 19 LAN configuration methods
DHCP DNS
Yes
Yes
No
Yes
No
Yes
After you have determined howto configure the iLO 3 MP LAN to get an IP address, you must
configure the iLO 3 MP LAN using the selected method.

Configuring the iLO 3 MP LAN using DHCP and DNS

DHCP automatically configures all DHCP-enabled servers with IP addresses, subnet masks, and
gateway addresses. All HP Integrity entry class servers with iLO 3 MP are shipped from the factory
with DHCP enabled.
When you use DHCP and DNS, you can connect to the iLO 3 MP by entering the default host
name in your browser rather than an IP address, only if the following conditions apply:
DHCP must be enabled (DHCP is enabled by default)
You are using a DHCP server that provides the domain name and the primary DNS server IP
address
The primary DNS server accepts DDNS updates
The primary DNS server IP address has been configured through the DHCP server
To configure the iLO 3 MP using DHCP and DNS:
1. Get the factory-set host name from the iLO 3 MP MAC address label on the right side of the
server, above the rail. The default host name is 14 characters long, consisting of the letters
mp followed by the 12 characters of the MAC address. For example: mp0014c29c064f.
This address is assigned to the iLO 3 MP hardware. The iLO 3 MP hardware has a unique
MAC address that identifies the hardware on the network.
IMPORTANT:
address of the server core LAN card.
2. Connect the LAN cable into the iLO 3 MP port at the rear of the server.
shows the location of the iLO 3 MP port.
3. Connect the LAN cable from the server to an active network port.
4. Apply ac power to the server (if not already done).
5. Open a browser, telnet, or Secure Shell client, and enter the iLO 3 MP IP address. The iLO 3
MP log on window appears.

Configuring the iLO 3 MP LAN using the RS-232 serial port

IMPORTANT:
Duplicate server IP addresses conflict and the servers cannot connect to the network.
The LC command enables you to configure an IP address, host name, subnet mask, and gateway
address.
RS-232 serial port (iLO 3 MP
LC command)
Yes No
Yes Yes
Yes Yes
No Yes
No Yes
No No
Make sure you get the MAC address of the iLO hardware and not the MAC
Do not configure duplicate IP addresses on different servers within the same network.
LAN configuration method
DHCP
DHCP, RS-232 serial port
RS-232 serial port
RS-232 serial port
RS-232 serial port
Cannot set up the LAN. Reconsider your criteria.
Connecting and setting up the console
Figure 10 (page 20)
49