Installing The Server Into A Rack Or Pedestal Mount; Installing The Server Into A Rack - HP Integrity rx3600 Installation Manual

17. Replace the memory carrier assembly cover and latch the top cover release lever closed. See
"Replacing the Memory Carrier Assembly Cover" (page
Figure 13 Processor Board Assembly (Front View)
Figure 14 shows the power connectors, the processor lock / unlock mechanism location and the
alignment holes. One processor is installed in the illustration.
Figure 14 Processor Alignment Holes and Lock/Unlock Mechanism

Installing the Server into a Rack or Pedestal Mount

This section provides instructions on how to install the server into a rack or a pedestal mount.

Installing the Server into a Rack

The following information describes how to install the server into an HP rack or an approved non-HP
rack.
32 Installing the System
13).